COTTER PIN |
LOCATION |
OUTRIGGER |
Remove Outriggers
Remove cotter7pin from outrigger by cutting tie strap. Either pull the out- rigger out from the front or insert a crowbar into the tube from the back and push the outrigger out.
Position Next Case In Line Up
Roll case approximately8 6’ from adjoining case. Remove casters on the end nearest to the next case. Allow casters to remain on opposite end to assist in pushing cases togeth- er - then remove them.
CAULK
FOAM TAPE
Remove Shipping Accessories From Case. Add Sealant.
Remove anything9from the case that may interfere with case joining. Apply the foam tape that is shipped loose in the case to the end breakers on each side of the case. Run a bead of sealant around the entire end before pushing cases tightly together.
BUMPER |
JOINT |
BUMPER |
SCREW |
Loosen Master Bumper
Loosen10screws on master bumper. Move bumper joint to a position for sliding between adjoining case bumper.
6 7
5
4 3 2 1
Bolt Cases Together Using Bolt Holes Provided
Push 11cases tightly together. Bolt cases together through the holes provided. Tighten until all margins are equal; do not over tighten. If bolt 5 interferes with shelf positioning, it may be removed once cases are set.
CAULK |
Add Sealant to Top Case Joint.
Once cases12are pushed tightly togeth- er and bolted run a bead of sealant along the top joint.
Ask about our case installation video available by request through your local Hill PHOENIX Sales or Field Service Representative.
11
