![](/images/new-backgrounds/1132550/13255025x1.webp)
Close joints of9front panel. The panel is slotted on the bottom to allow left or right adjustment as required.
TOP SILL
JOINT
TOP SILL
CURVED FRONT |
PANEL |
CURVED FRONT |
PANEL JOINT |
Install curved10front panel joint (if cases come equipped with curved front pan- els). Curved panel joints are shipped loose in the case and are attached with the screws provided. Wide joints (1”) are for
Attach 11lower front panel (for cases on 11” baseframes). Slots and tabs are designed for easy installation without fasteners. The lower front panel is slot- ted to allow adjustment left or right as required.
GLASS PRESSURE BAR
REAR SILL
REAR SILL
JOINT
MULLION
Install top12sill joint. The top sill joints are shipped loose in the case. The front lip of the joint fits into the crevice between the top sill and the glass pressure bar. The rear lip is attached to the back of the case with the screws provided.
Insert kickplate into “J” rail. Slide the kickplate15up and behind the lower front panel bracket then down on the “J” rail.
Install rear13sill joint. The rear sill joints are shipped loose in the case. The bot- tom portion of the joint should be slid on the rear sill first then the top lip fits between the rear sill and the mullion. Secure the joint underneath the rear sill with the screws provided.
Insert nose16bumper into master bumper channel. Roll nose bumper into channel along entire lineup (up to 96’). We rec- ommend that the nose bumper be left in the store 24 hours before installing. DO NOT STRETCH the bumper during installation as it will shrink to its original length and leave a gap.
9
Install the14“J” rail onto the case base rail. For cases with an 11” baseframe, the “J” rail easily slides over the base rail and requires no fasteners. Space “J” rails evenly along the base rail (2 “J” rails per 6’, 8’, and 12’ case). For cases with the 7” baseframe there is a single “J” rail that is screwed into place.
NOTE: An easy technique for one person is to press against nose bumper with leg as you guide bumper into channel with a screen spline. Insert bottom first.