Removal and replacement procedures
3.Turn the computer
4.Open the computer as far as possible.
5.Release the ZIF connector 1 to which the TouchPad board cable is connected and disconnect the TouchPad board cable from the system board.
6.Release the ZIF connector 2 to which the LED board cable is connected and disconnect the LED board cable from the system board.
7.Remove the two Phillips PM2.0×5.0 screws 3 that secure the top cover to the computer.
8.Lift the front edge of the top cover 1 until it rests at an angle.
9.Remove the top cover by pulling it away from the computer 2 at an angle.
Reverse this procedure to install the top cover.
Maintenance and Service Guide |
