On/Off Switch
Removal
1.
Relieve pressure; page 6.
Installation
1.Install new ON/OFF switch (51) so tabs of switch snap into place on inside of pressure control housing.
2.Fig. 10. Remove four screws (11) and display/cover (12).
3.Pull display connector wings (A) open on PC board and pull display connector out.
4.Disconnect ON/OFF switch connector (B) from PC board.
5.Press in on two retaining tabs on each side of ON/OFF switch (51) and remove switch.
2.Connect ON/OFF switch connector (B) to PC board.
3.Push display connector into PC board close dis- play connector wings (A) on PC board.
4.Install display/cover (12) with four screws (11).
8
100a
44
147
44
Ref 4
95
A
|
| 147a | 100p |
12 |
|
| 100q |
B |
|
| |
|
|
| |
11 | D | 176 |
|
| 178 |
| |
| E | 141 |
|
| 22 |
| |
|
|
| |
| 33 |
|
|
5150
22
13
Fig. 10
ti1849a
309411 13
