USING THE REMOTE TO CONTROL
CABLE BOX/SATELLITE FUNCTIONS
Operating the precoded function for your cable/satellite box.
This remote is designed to operate different types of cable boxes and satellite systems. You must first program the remote to match the remote system of your cable/satellite box. (refer to page 31)
1.Turn ON your cable/satellite box.
2.Aim the remote control at the front of your cable/satellite box.
3.Press the CBL/SAT button to switch to the cable/satellite box
4.Hold down the CBL/SAT button on the remote, enter the two digit preset code that matches your cable/satellite box as shown on page 31. The remote will turn off your cable/satellite box when the correct two digit preset code is entered. When this occurs, the remote control is programmed for your cable/satellite box. If the cable/satellite box does not turn off after five seconds, try a different two digit preset code.
5.The remote will now control you cable/satellite box.
CBL/SAT button
This button allows the remote to control your cable/satellite box by setting it to CBL/SAT mode.
| POWER |
TV | CBL/SAT DVD/VCR |
PIP | SWAP MOVE |
FREEZE |
PIP CH
HELPTV/VCR
MENU
MUTE | LAST CH |
| EXIT |
EXCLUSIVE TV buttons 
These buttons are for
operating the TV.
VOL CH
PRECODED CABLE/SATELLITE Box buttons
These buttons transmit the chosen precoded
CABLE/SATELLITE codes.
1 2 3
4 5 6
7 8 9
INPUT 0 SLEEP
REC
C.S. RECALL
NOTES:
1.If your cable/satellite box cannot be operated after performing the above procedures, your cable/satellite box s code has not been precoded into the remote.
2.In the unlikely event that your cable/satellite box cannot be operated after performing the above procedures, please consult your cable/satellite box s operating guide.
3.The remote control will remember the codes you have programmed until the batteries are removed from the remote control. After replacing the batteries repeat the entire programming procedure as stated above.
30
