Hitachi 32PD5000 Remote control, English, Loading Batteries, Handling the Remote Control

Remote control

POWER OFF button 13

POWER ON button 13

MUTE button 14

RGB/VIDEO buttons 14

PinP button 34

AUTO button 16

MENU button 16

OK button 16

ID button 16

			VOL
RGB 1	RGB 2	MUTE	VOL
AV1	AV2	AV3	AV4

AUTO PinP SIZE RECALL

MENU

OK

ID ID SET

13POWER ON/OFF button

14VOLUME UP/DOWN buttons

15SIZE button

15RECALL button

16RETURN button

16SELECT/ADJUST buttons

16ID SET button

ENGLISH

Loading Batteries

1. Open the battery cover.

• Slide back and remove the battery cover in the direction of the arrow.

2.Load batteries.

•Load two Size AA batteries included observing the correct polarities.

3.Close the battery cover.

•Replace the battery cover in the direction of the arrow and snap it back into place.

Handling the Remote Control

Use the remote control within about 5 m from front of the unit’s remote-control sensor and within 30 degrees on both sides.

With in 30

With in 30 degrees degrees

About 3m About 3m

About 5m

CAUTION

•Do not use new and old batteries together. The batteries could explode or leak, resulting in fires, physical injury, or stains.

•When loading batteries, observe their correct polarities as marked on the product. If loaded in the wrong direction, the batteries could explode or leak, resulting in fires, physical injury, or stains.

ATTENTION

•Do not drop or impact the remote control.

•Do not splash the remote control with water or put it on a wet object to avoid possible failures.

•Before leaving the remote control out of use for an extended period of time, remove the batteries from it.

•If the remote control begins to lack responsiveness, replace the batteries.

•Strong light such as direct sunlight impinging on the photoreceptor of the remote control can cause operational failure. Position this unit to avoid direct contact with such light.

9