Hitachi 42PMA500, 42PD5000, 32PD5000 user manual Installation Location

Installation Location

WARNING

Plaster board or thin ply wood, etc.

Pillar or

thick ply wood.

■The wall where the wall-mount unit is to be installed must be capable of long-term support of the total load of the plasma TV and wall-mount unit. Measures should also be taken to ensure sufficient strength to withstand the force of earthquakes, vibration and other external forces.

Incorrect installation can cause the plasma TV to fall and cause injury.

Total load of the (plasma TV + wall-mount unit)

=26kg•••CL32-PD2100 34kg•••CL37-PD2100 37kg•••CL42-PD2100

●Installation on a wooden wall

Always install so that the load is supported by a pillar. If the strength of the pillar is insufficient, add reinforcement. Do not install on decorative posts or plaster board.

●Installation on a concrete wall

Use commercially available anchors that are capable of fully supporting the load of the plasma TV.

CAUTION

■ Avoid installing in		■ Do not block the
locations where the		10cm￿	ventilation holes.
temperature and		or more	Also provide
humidity are			sufficient clearance
excessively high,	10cm￿		in regard to the
and where contact	or more		surroundings to
with water is			avoid blocking the
possible.		10cm￿	ventilation.
These can result in fire		or more	The internal
or electrical shock.			temperature could
			elevate and possibly
			result in fire.
■ Do not install close		■ Install only on a
to an air-			vertical surface.
conditioner intake			Avoid sloped
or outlet.			surface. Also, do
Do not install in			not install facing
locations where there			upward.
is excessive amounts			The internal
of dust, oily smoke or			temperature could
tobacco smoke.			elevate and possibly
Fire could result.			result in fire.
			Injury or damage could
			also result from falling.

– 3 –