Hitachi 42PD5000 user manual System Color System, Video Input, AV2 1st step AV2 2nd step

01 QR58553-英語-初校03.10.15 10:47 AM ページ38

OPERATING INSTRUCTIONS (continued)

SETUP MENU

MENU

Selected characters

System

Color System

AV1

AV2

AV3

AV4

Video Input

AV1

AV2 (1st step)

AV2 (2nd step)

AV4

Picture			Setup				Setup
Audio		OK		System	System 1			Color System
Timer						OK
				Color System
Function				Video Input				AV1	Auto
Setup				Audio Input				AV2	PAL
Language				Scart Output	Monitor			AV3	SECAM
Select				RGB1	DVI-STB			AV4	PAL
OK	Set			RGB2	Component
					HDTV			Select	Return	Exit
				Select OK Set	Return

Setup				Setup
	System	System 1			Video Input
	Color System		OK
					AV1	Auto
	Video Input
	Audio Input				AV2	Composite/Component
	Scart Output	Monitor			AV3	Auto
	RGB1	DVI-STB			AV4	S.Video
	RGB2	Component
		HDTV
	Select OK Set	Return			Select	Return	Exit

Setup				Setup
	System	System 1			Audio Input
	Color System		OK		AV1		Stereo
	Video Input				AV2		L/Mono
					AV3		Stereo
	Audio Input
	Scart Output	Monitor			AV4		L/Mono
	RGB1	DVI-STB			Select	Return		Exit
	RGB2	Component
		HDTV
	Select OK Set	Return

	▲			▲	Setup hint
	System1		System2		Do not change the original setting.
					(System1 : Europe/Asia, System2 : North America)
					This should correspond to the color system of the signal from the
					equipment that is connected to AV1 video input terminal.
Auto		PAL		SECAM	• Normally, set this to Auto. The system of the input signal will be
					automatically recognized.
NTSC3.58			NTSC4.43		• If the input signal contains much noise or has a low level at Auto and the
					operation is found erratic, set this to match the input signal.

•When the component signal is received, this would be not available (grayed out).

(Same to AV1)

			This should correspond to the signal mode of the signal from the
			equipment that is connected to AV1 video input terminal.
Auto	HDTV	SDTV/DVD	• Normally, set this to Auto. The signal mode of the input signal will be
			automatically recognized.

•If the input signal contains much noise or has a low level at Auto and the operation is found erratic, set this to match the input signal.

RGB		Composite/Component			This should correspond to the signal mode of the signal from the
					equipment that is connected to AV2 video input terminal.
Auto		HDTV		SDTV/DVD	This step should be set only when [Composite/Component] is selected on
					the 1st step. And the procedure is same to AV1.
					• If the signal from the equipment that is connected to AV4 Scart input
	S.Video		Composite		terminal is S.Video or Composite, set this to correspond to that signal.
					• If the signal is RGB, it will be automatically recognized and this setting
					will have no effect.

38