USING THE REMOTE TO CONTROL DVD FUNCTIONS
Operating the precoded function for your DVD Player.
This remote is designed to operate different types of DVD Players. You must first program the remote to match the remote system of your DVD Player. (refer to page 29)
1.Turn ON your DVD Player.
2.Aim the remote control at the front of your DVD Player.
3.Press the DVD/VCR button to switch to the DVD Player
4.Hold down the DVD/VCR button on the remote, enter the two digit preset code that matches your DVD Player as shown on page 29. The remote will turn off your DVD Player when the correct two digit preset code is entered. When this occurs, the remote control is programmed for your DVD Player. If the DVD Player does not turn off after five seconds, try a different two digit pre- set code.
5.The remote will now control you DVD Player.
| POWER |
TV | CBL/SAT DVD/VCR |
SWAP MOVE
PIP | FREEZE |
DVD button
This button allows the remote to control your DVD Player by setting it to DVD mode.
PIP CH
HELPMENU
SELECT
MUTE | LAST CH |
| EXIT |
EXCLUSIVE TV buttons 
These buttons are for
operating the TV.
VOL CH
1 2 3
4 5 6
7 8 9
PRECODED DVD buttons These buttons always transmit the chosen precoded DVD codes. When the remote is in DVD mode, EXIT button is used as ENTER button.
INPUT 0 STATUS
REC | TV/VCR | PIX |
NOTES:
1.If your DVD Player cannot be operated after performing the above procedures, your DVD PlayerÕs code has not been pre- coded into the remote.
2.In the unlikely event that your DVD Player cannot be operated after performing the above procedures, please consult your DVD Player operating guide.
3.The remote control will remember the codes you have programmed until the batteries are removed from the remote control. After replacing the batteries repeat the entire programming procedure as stated above.
NOTE: Refer to instruction manual of the DVD Player for operation of the buttons exclusively for the DVD Player.
27
