Hitachi 42HDT50, 50HDT50, 32HDT50 important safety instructions Phones Jack

FRONT PANEL CONTROLS

FIRST TIME USE

POWER button

Display Monitor “MAIN POWER” button

This power button is for the complete system, and must be turned ON/OFF manually. POWER” to ON condition (lights red) for stand-by mode.

STANDBY (RED) ON (GREEN) MAIN POWER

32”/42”

AVC POWER button

It is recommended to leave the “MAIN

or

MAIN POWER

50”

The AVC power can be turned ON/OFF manually or by remote control. Turning on the AVC Power will only turn on the AVC box if the “MAIN POWER” of the display monitor is off.

POWER light indicator

To turn the monitor ON, press the main power switch located on the lower right side of the monitor (lower left for 50”). A red stand- by indicator lamp located on the lower right corner of the front bezel will illuminate (lower left for 50”). The PDP is now ready for

	Indicating Lamp	Power Status	Operating
	Off	Off	When the main power switch is set
			OFF.
	Lights Red	Off	When the main power switch on the display
		(Stand-by)	monitor is ON, and the AVC Center is OFF.
	Lights Green	On	Display monitor MAIN POWER is ON and
			AVC Center power is ON.
	Lights Orange	Off	Display monitor MAIN POWER is ON and
	(Flashing)	(Power Saving)	and AVC Center power is ON, with no signal
			input except antenna (no sync. signal).
remote on/off operation.

REMOTE CONTROL sensor

Point your remote at this area when selecting channels, adjusting volume, etc.

FRONT INPUT JACKS (for VIDEO: 5)

Use these audio/video jacks for a quick hook-up from a camcorder or VCR to instantly view your favorite show or new recording. press the VID5 button on the remote control button and VIDEO: 5 appears in the top right corner of the TV screen. If you have mono sound, insert the audio cable into the left audio jack.

PHONES JACK

Use this jack for your head-phones. The TV’s internal speakers can also be heard. Turn off the internal speakers (see page 47) if you wish to listen to the head-phones only.

LEARNING AV NET Sensor

Point your equipment’s remote control at this area while using the AV NET Learning Wizard.

NOTES: 1. Your HITACHI Plasma TV will appear to be turned OFF (lights orange) if there is no video input when VIDEO: 1, 2, 3, 4, 5, or RGB is selected. Check the Power Light to make sure the Display Monitor is turned off or in Stand-by mode (lights red) when not in use.

2.Remote Control can not turn ON/OFF the “MAIN POWER” of the display monitor.

10