2.15 GUIDE+ OSD Adjustment
Adjustment preparation
(1) Receive any signal in ANT A.
(2) Set picture controls to shipping conditions.
(3) Convergence Adjustment must be completed.
Adjustment procedure
(1) Go to VIDEO CHROfvlA ADJUST mode by
pressing INPUT and Power button on Control
Panel at the same time.
(2) Go to GUIDE+ mode using A,v buttons on
(3) Fusing VOL A,‘I buttons move the GUIDE+
OSD to the left or right and adjust so that OSD
is in the A position according to next table for
each PTV size.
(4) By using CH &‘I buttons move the GUIDE+
OSD up or down and adjust so the OSD is in the
B position according to next table for each PTV
size.
GUIDE+
OSD
(5) When GUIDE+ OSD is adjusted then adjust the
PinP inside the OSD box by using the CURSOR
buttons on the R/C to move PinP up or down and
left or right so the PinP is inside the OSD box
position according to next reference.
PinP for GUIDE+
NOTE: Use a Crosshatch signal or Single Cross signal
to make this adjustment and be sure the pattern
signal used is equal for upper, bottom, left and
right sides of PinP for GUIDE+. (Center as
reference.)