Hitachi 8450H/R manual Write operation was performed when power supply was

Ch 2: Installation and Use of Devices

No.	Message	Type	Operator-	Meaning
			alert lamp
29	Load Fail	Error	Blinking	• Loading the tape failed.
				• A load command or change partition command to read
				the system area of the tape failed. Use a new cartridge.
30	Load Tape	Information	—	This is displayed when the tape load button is pressed.
31	Loading	Status	—	• The cartridge is being moved from the magazine to the
				drive.
				• The cartridge is being loaded by the drive.
32	Locate	Status	—	The drive is moving the tape to the point specified by the
				host.
33	Mag Check	Status	—	The autoloader is checking the magazine slot.
34	Mag Eject	Status	—	The autoloader is ejecting the magazine.
35	Mag Loaded	Status	—	The magazine has been loaded into the autoloader and
				checked.
36	Media Removal	Error	On	An attempt was made to eject a cartridge when cartridge
	Prevented			ejection is inhibited. Use the SCSI command or reset to
				cancel the ejection inhibition.
37	New FW!!!	Status	—	Upgrading of firmware completed.
38	No EODmark	Error	Blinking	Data in the tape contains no EOD (A possible cause is that
				a write operation was performed when power supply was
				abnormal).
39	Partition	Status	—	The drive is switching a two-partition tape to a different
				partition.
40	Partition 1 too	Error	On	Formatting failed because the size for one partition is too
	large			large. Decrease the partition size or use a longer tape.
41	Read	Status	—	The drive is reading data from tape.
42	Read Fail	Error	Blinking	Reading data failed. Reset the position of the data, and
				retry.
43	Ready xxm	Status	—	A cartridge has been loaded into the drive, and the tape
				motion command has become executable (“xxm” indicates
				the length of the tape loaded. For a write-protected
				cartridge, “Read Only” is displayed).
44	Rewind	Status	—	The drive is rewinding the tape to the beginning of the
				partition.
45	SCSI Error	Error	On	An SCSI command error has been detected. Check the
				SCSSI cable for connection, and retry.
46	SCSI ID: x	Information	—	Indicates the SCSI ID of the autoloader. This is displayed for
				two seconds succeeding to the product ID when power is
				turned on.
47	Search <<	Status	—	The drive is searching for a record, file mark, set mark, or
				BOD to the beginning of the tape.
48	Search >>	Status	—	The drive is searching for a record, file mark, set mark, or
				EOD to the end of the tape.
49	Select Tape	Information	—	This is displayed when the select button is pressed.

18 Hitachi PC VisionBase 8450H/R Server