Hitachi 8450H/R manual Succeeding cartridges

				Ch 2: Installation and Use of Devices
No.	Message	Type	Operator-	Meaning
			alert lamp
50	Self Test	Status	—	The autoloader is executing the power-on self-test.
51	SemiLoaded	Status	—	Although a cartridge is in the drive, it has not been loaded
				(“semi-loaded” status).
52	Stray Tape:	Information	—	The autoloader does not contain a magazine for taking a
	Insert Empty			cartridge from the drive. Insert a magazine with an empty
	Mag			slot.
53	Tape Fault	Error	Blinking	The drive contains a defective cartridge.
				Use a new DDS-compliant tape.
54	Tape Full	Error	On	A read, space, write, or write file mark command detected
				an unexpected EOP (For a read operation, this message
				sometimes indicates that data extends over the current and
				the succeeding cartridges).
55	Tape has DC	Error	On	Although compressed data was detected when a read
	Data			command was executed, the drive settings do not
				correspond with decompression of data (The drive is
				factory-set to compressed mode. If it is unchanged, this
				error cannot occur).
56	Tape Position	Error	Blinking	A write, read, space, or rewind command terminated
	Lost			abnormally. The current tape position is immediately after
				the erroneous data area. Reset the data position, and retry.
57	Tape Stuck	Error	Blinking	A cartridge is stacked in the drive. Attempt to forcibly eject
				the cartridge. If the error still recurs, contact the store where
				you bought the system or call the maintenance personnel.
58	Unloading	Status	—	• The drive is unloading a cartridge.
				• The drive is ejecting a cartridge and returning it to the
				magazine.
59	UpgradeErr	Error	Blinking	Upgrading firmware failed. Check the SCSI cable for
				connection, and retry.
60	Worn Media	Error	Blinking	A high error ratio was detected during a write operation.
				This indicates that the service life of the cartridge is coming
				to an end. Copy the data in the cartridge to a new one, and
				discard the old one.
61	Write x.y	Status	—	The drive is writing data to tape (“x.y”:1 is the accumulated
				compression ratio since power-on or since the compression
				ratio was cleared).
62	Write Protected	Error	Blinking	When a write, write file mark, or erase command was
	Tape			executed, processing could not be completed because the
				cartridge was write-protected. Cancel the write protection,
				and retry.
63	Write Fail	Error	Blinking	A write, write file mark, or erase command failed. Use a new
				cartridge.

Hitachi PC VisionBase 8450H/R Server 19