English
ASSEMBLY AND ADJUSTMENTS
ESTIMATED ASSEMBLY TIMES 20~40 MINUTES
ASSEMBLY INSTRUCTIONS
WARNING
For your own safety, never connect plug to power source outlet until all assembly and adjustment steps are completed, and you have read and understood the safety and operating instructions.
TOOLS NEEDED
Slotted screwdriver | 8" & 10" Ajustable wrenches |
| |
Combination wrenche |
|
| Combination square |
Framing square | Socket wrench with |
| 23 mm. socket |
WARNING
The Drill Press is very heavy and MUST be assembled with the help of 2 PEOPLE OR MORE, to safely assembly it.
COLUMN SUPPORT TO BASE (Fig. A)
1.Position the base (1) on the floor.
2.Place the column (2) on the base, aligning the holes in the column support with the holes in the base.
3.Locate the four long hex bolts (3) from the loose parts bag.
4.Place a bolt in each hole through the column support and the base. Tighten with an adjustable wrench.
Fig. A
2
33
1
Fig. B
2
3
4
5
1
4.(Fig. C) Loosen the support lock (2). Raise the table arm assembly by turning the crank handle (1) clockwise. Tighten the support lock.
5.Place the table (6) in the table arm assembly. Tighten the table lock handle (7).
Fig. C
6
7
2
1
INSTALLING BATTERY FOR LASER GUIDE (Fig. C-1)
1.Open the cover of battery box.
2.Install 2 pieces of 1.5V 3A batteries into the battery box.
3.Close the cover.
4.Turn on the switch to check the LASER GUIDE.
Fig. C-1
INSTALLING THE TABLE (Fig. B and C)
1.Locate the table crank (1) and support lock (2) from the loose parts bag.
2.Insert the support lock handle from the left to right into the hole (3) at the rear of the table support assembly. Tighten by hand.
3.Install the table crank handle (1) onto the small shaft (4), aligning the set screw (5) with the flat surface of the shaft (4). Tighten the set screw with a hex wrench.
NOTE: Replace the batteries with batteries that have a rating of 1.5 volts (Number 4 series and AAA size or equivalent). When replacing the batteries, the battery guide should be thoroughly cleaned. Use a soft paintbrush or similar device, to remove all sawdust and debris.
— 11 —
