Important Safety Instructions

CANADIAN RSS NOTICE

This device complies with Industry Canada RSS-210. Operation is subject to the following two conditions:

(1)this device may not cause harmful interference, and

(2)this device must accept any interference, including interference that may cause undesired operation.

Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio RSS-210. L’exploitation est autorisée aux deux conditions suivantes:

(1)l’appareil ne doit pas produire de brouillage, et

(2)l’utilisateur de l’appareil doit accepter tout brouillage radio électrique subi, si le brouillage est susceptible d’en compromettre le fonctionnement.

This device meets the exemption from the routine evaluation limits in section 2.5 of RSS-102 and compliance with RSS-102 RF exposure, users can obtain Canadian information on RF exposure and compliance.

Le dispositif rencontre l’exemption des limites courantes d’évaluation dans la section 2.5 de RSS-102 et la confirmité á l’exposition de RSS-102 rf, utilisateurs peut obtenir l’information Canadienne sur l’exposition et la conformité de rf.

U.S. FEDERAL COMMUNICATIONS COMMISSION NOTICE

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

—Reorient or relocate the receiving antenna.

—Increase the separation between the equipment and receiver.

—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

—Consult the dealer or an experienced radio/TV technician for help.

MODIFICATIONS

FCC regulations state that any changes or modifications made to this device that are not expressly approved by Hitachi America, Ltd. may void the user’s authority to operate the equipment .

CABLES

Connections to this device must be made with shielded cables with metallic RFI/EMI connector hoods to maintain compliance with FCC Rules and Regulations.

Any cables or power cords or power adapters supplied with the system must be replaced with identical parts in order to assure compliance.

You may order those replacement parts from Hitachi.

DECLARATION OF CONFORMITY

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1)this device may not cause harmful interference, and

(2)this device must accept any interference received, including interference that may cause undesired operation.

For questions regarding this declaration, contact: Hitachi America, Ltd.

900 Hitachi Way

Chula Vista, CA. 91914 800.448.2244 (800.HITACHI) ATTN: Customer Relations

LEAD NOTICE

This product contains lead. Dispose of this product in accordance with applicable environmental laws. For product recycling and disposal information, contact your local government agency or www.erecycle.org (in California), the Electronic Industries Alliance at www.eiae.org (in the U.S.) or the Electronic Product Stewardship Canada at www.epsc.ca. (in Canada). For more information, call 800.HITACHI.

This unit meets ENERGY STAR for A/V program requirements.

If no audio input signal has been detected for 30 minutes, this unit automatically powers down to save you energy.

Press the Power button on the remote control or top panel to wake the unit.

3