English

The laser line is adjusted to the width of the saw blade at the time of factory shipment. Adjust the positions of the saw blade and the laser line taking the following steps to suit the use of your choice.

Switch

Laser line

Fig. 14

(1)Light up the laser marker and make a groove of about 3/16 in. (5mm) deep on the workpiece that is about 1-1/2 in. (38mm) in height and 3-1/2 in. (89mm) in width. Hold the grooved workpiece by vise as it is and do not move it.

Workpiece

 

 

Saw blade

 

 

 

 

 

 

 

 

 

 

Marking (pre-marked)

Cutting width

Fig. 15

(2)Then insert a 4mm hex. bar wrench in the 12 diameter hole on the side of the gear case, turn the hex. socket set screw to move the laser line. (If you turn the Hex. socket screw clockwise, the laser line will shift to the right and if you turn it counterclockwise, the laser line will shift to the left.) When you work with the ink line aligned with the left side of the saw blade, align the laser line with the left end of the groove. (Fig. 16) When you align it with the right side of the saw blade, align the laser line with the right side of the groove.

ø12 Hole

4mm Hex.

bar wrench

 

Laser line

Laser line

Marking (pre-marked)

Fig. 17

NOTE:

Check and make sure on a periodic basis if the position of the laser line is in order. As regards the checking method, draw a right-angle ink line on the workpiece with the height of about 1-1/2 in. (38mm) and the width of 3-1/2 in. (89mm), and check that the laser line is in line with the ink line [The deviation between the ink line and the laser line should be less than the ink line width (0.5mm)]. (Fig. 17)

PRACTICAL APPLICATIONS

WARNING:

*To avoid personal injury, never remove or place a workpiece on the table while the tool is being operated.

*Never place your limbs inside of the line next to warning sign while the tool is being operated. This may cause hazardous conditions (see Fig. 18).

Line

Warning

Line

sign

 

 

Turn

Move

Groove

Laser line

Laser marker

Laser holder

Left

 

Right

 

Hex socket

Gear case

bolt

Hex bar wrench

 

 

(Accessories)

Fig. 16

(3)After adjusting the position of the laser line, draw a right-angle ink line on the workpiece and align the ink line with the laser line. When aligning the ink line, slide the workpiece little by little and secure it by vise at a position where the laser line overlaps with the ink line. Work on the grooving again and check the position of the laser line. If you wish to change the laser line’s position, make adjustments

again following the steps from (1) to (3).

10

Fig. 18

1.Switch operation

Pull the trigger to turn on the switch, release it to shut it off.

After releasing the trigger, make sure the trigger has gone all the way back and the switch is turned off.

Hole

Trigger switch

Fig. 19

WARNING:

This will ensure that the power tool cannot be turned on accidentally or by someone (especially a child) who is not qualified to use the power tool.

To prevent unauthorized operation of this tool, insert a padlock to the hole in the switch trigger to disable the use of the switch.

2.Using the Vise Assembly (Standard accessory)

(1)The vise assembly can be mounted on either the left fence {Fence (B)} or the right fence {Fence (A)} by loosening the 6mm wing bolt

(A).