English
| 6mm Wing bolt | |
Steel | (Optional accessory) | |
Holder | ||
square | ||
(Optional | ||
| accessory) | |
6mm Wing |
| |
nut (Optional |
| |
accessory) | Height adjustment Base surface | |
| bolt 6mm (Optional | |
| accessory) | |
| Fig. 9 |
4.Stopper for precision cutting ... (Stopper and holder are optional accessory)
The stopper facilitates continuous precision cutting in lengths of 11 in. to
To install the stopper, attach it to the holder with the 6mm wing bolt as shown in Fig. 10.
CAUTION:
Workpiece
Stopper
(Optional accessory)
Fig. 12
| Holder |
| (Optional accessory) |
| 6mm Wing nut |
| (Optional accessory) |
Move |
|
6mm Wing bolt | Height adjustment bolt 6mm |
(Optional accessory) | (Optional accessory) |
Fig. 10
5.Confirmation for use of sub fence (B) …(Standard accessory)
WARNING:
In the case of left bevel cutting, rotate the sub fence (B). Supposing it is not able to rotate it, It will contact the blade or some part of the tool, causing in serious injury to operator.
Sub fence (B)
Fence (B)
Fig. 11
6.Position adjustment of laser line (Only Model C10FCH2)
WARNING:
*Make sure before plugging the power plug into the receptacle that the main body and the laser marker are turned off.
*Exercise utmost caution in handling a switch trigger for the position adjustment of the laser line, as the power plug is plugged into the receptacle during operation.
If the switch trigger is pulled inadvertently, the saw blade can rotate and result in unexpected accidents.
*Do not remove the laser marker to be used for other purposes.
Fig. 13
*Laser radiation — Do not stare into beam.
*Laser radiation on work table. Do not stare into beam.
If your eye is exposed directly to the laser beam, it can be hurt.
*Do not dismantle it.
*Do not give strong impact to the laser marker (main body of tool); otherwise, the position of a laser line can go out of order, resulting in the damage of the laser marker as well as a shortened service life.
*Keep the laser marker lit only during a cutting operation. Prolonged lighting of the laser marker can result in a shortened service life.
*Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure.
NOTE:
*Perform cutting by overlapping the ink line with the laser line.
*When the ink line and the laser line are overlapped, the strength and weakness of light will change, resulting in a stable cutting operation because you can easily discern the conformity of lines. This ensures the minimum cutting errors.
*In outdoor or
*Do not tug on the cord behind the motor head or hook your finger, wood and the like around it; otherwise, the cord may come off and the laser marker may not be lit up.
Ink lining can be easily made on this tool to the laser marker. A switch lights up the laser marker. (Fig. 14)
Depending upon your cutting choice, the laser line can be aligned with the left side of the cutting width (saw blade) or the ink line on the right side.
9