9.Installing the holders ... (Optional accessory)
The holders help keep longer workpieces stable and in place during the cutting operation.
(1) As indicated in Fig. 14, use a steel square for aligning |
the upper edge of the holders with the base surface. |
Loosen the 6 mm wing nut. Turn a height adjustment |
(2)Miter cutting and compound cutting (Miter cutting + bevel cutting)
Upon lowering the motor section, the lower guard is raised and the saw blade appears.
Align the ink line with the saw blade (Fig. 17).
bolt 6 mm, and adjust the height of the holder. |
(2) After adjustment, firmly tighten the 6 mm wing nut |
and fasten the holder with the 6 mm knob bolt |
(optional accessory). If the length of Height |
Adjustment Bolt 6 mm is insufficient, spread a thin |
plate beneath. Make sure the end of Height |
Adjustment Bolt 6 mm does not protrude from the |
holder. |
6 mm knob bolt (Optional accessory)
Move the 
guard 
backward 
Sub fence (B)
Lower guard
6 mm knob bolt
Marking
Steel square Holder 
(Optional 
accessory) 
6 mm wing nut | Base surface |
|
(Optional accessory) | Height adjustment bolt 6 mm |
| (Optional accessory) |
| Fig. 14 |
10.Stopper for precision cutting ... (Stopper and holder are optional accessory)
The stopper facilitates continuous precision cutting in lengths of 285 mm to 450 mm.
To install the stopper, attach it to the holder with the 6 mm knob bolt as shown in Fig. 15.
Workpiece Stopper (Optional accessory)
Holder (Optional accessory)
6 mm knob bolt | Move |
(Optional accessory) |
|
Fig. | 15 |
11.Using an ink line
(1) Right angle cutting
Loosen the 6 mm knob bolt and contact the tip of the guard with the workpiece.
Aligning the ink line on the workpiece with the groove of the guard, the workpiece is cut on the ink line (Fig. 16).
Saw blade groove | 6 mm knob |
| bolt |
Fig. 17
CAUTION
In some arrangements when the turntable is rotated, the guard projects from the fence surface. Loosen the 6 mm knob bolt and push the guard to the retracted position. Never lift the lower guard while the saw blade is rotating. When cutting at an angle to the right or more, please slide the guard to the rear. The guard and
12.Position adjustment of laser line
WARNING
* Make sure before plugging the power plug into the receptacle that the main body and the laser marker are turned off.
* Exercise utmost caution in handling a switch trigger for the position adjustment of the laser line, as the power plug is plugged into the receptacle during operation.
If the switch trigger is pulled inadvertently, the saw blade can rotate and result in unexpected accidents.
* Do not remove the laser marker to be used for other purposes.
CAUTION
Marking | Guard Workpiece | Fig. 18 |
Fig. | 16 |
|
10