When cutting the workpiece which has the dimension of “*” there might be some possibility of the lower end of the circular saw to touch with the workpiece, even if the motor head is located at the lower limit position. Pay attention when cutting the workpiece. For further details, refer to “PRACTICAL APPLICATIONS” on page 13. Mount the auxiliary board on the fence surface (Refer ( ) the thickness of auxiliary board). Refer to "5. Cutting large workpieces" on page 14 (Fig. 31).
STANDARD ACCESSORIES
1 2 3
45
Fig. 3
1305 mm TCT Saw blade (1 piece) (For wood)
2 Dust bag (1 piece)
For how to use, refer to page 19.
3 Vise Assembly w/knob bolt (1 piece)
For how to use, refer to page 13.
4 17 mm BOX wrench (1 piece)
5 Holder (1 piece)
For how to use, refer this page.
6 Washer (C) (Only For Australia)
OPTIONAL ACCESSORIES...sold separately
1Extension Holder and Stopper
2 Crown molding Vise Ass’y (Include Crown molding Stopper (L))
3 Crown molding Stopper (L)
4 Crown molding Stopper (R)
NOTE
Accessories are subject to change without any obligation on the part of the HITACHI.
PREPARATION BEFORE OPERATION
Make the following preparations before operating the power tool:
1. Installation
281mm | 256mm |
9mm
3holes
244 mm 281 mm
Base 8mm bolt
25 mm thick bench
Work bench | 8 mm nut |
Fig. 4
Attach the power tool to a level, horizontal work bench in accordance with Fig. 4.
Select 8 mm diameter bolts suitable in length for the thickness of the work bench.
Bolt length should be at least 40 mm plus the thickness of the work bench.
For example, use 65 mm or larger bolts for a 25 mm thick work bench.
The holder attached to the rear of the base helps stabilize the power tool.
Holder adjustment:
Loosen the 6 mm bolt with the 10 mm box wrench. Adjust the holder until its bottom surface contacts the work bench surface.
After adjustment, firmly tighten the 6 mm bolt.
APPLICATIONS
Wood and aluminum sash.
6 mm Bolt
Move Holder
Adjust the holder until its bottom surface contacts the work bench surface.
Fig. 5
6