(1)Turn the 8 mm depth adjustment bolt, change the height where the bolt head and the hinge contacts, and adjust the lower limit position of the saw blade.

NOTE

Confirm that the saw blade is adjusted so that it will not cut into the turntable.

4. Lower limit position of saw blade when cutting a large workpiece

NOTE

When cutting a workpiece exceeding 107 mm in height in right-angle cutting or 70 mm in left bevel angle cutting or 45 mm in right bevel angle cutting, adjust the lower limit position so that the base of the motor head (see Fig. 10-a) will not come in contact with the workpiece.

To adjust the lower limit position of the saw blade, follow the procedure (1) shown in Fig. 10-a.

(1)Lower the motor head, and turn the 8 mm depth adjustment bolt and make adjustments so that there can be a clearance of 2 mm to 3 mm between the lower limit position of the motor head and the top of the workpiece at the saw blade's lower limit position where the head of the 8 mm depth adjustment bolt

contacts the hinge.

5.Confirmation for use of sub fence (A)

WARNING

In the case of right bevel cutting, turn the sub fence

(A)clockwise. Unless it is turned clockwise, the main body or saw blade may contact the sub fence (A), resulting in an injury.

This power tool is equipped with a sub fence (A).

In the case of direct angle cutting and left bevel angle cutting, use the sub fence (A). Then, you can realize stable cutting of the material with a wide back face.

In the case of right bevel cutting, raise the sub fence

(A)up as illustrated in Fig. 11 and then turn it clockwise.

Left bevel angle cutting

 

 

Direct angle cutting

Turn

Right bevel angle

 

 

 

 

 

cutting

Fence (A)

 

 

 

 

Sub fence (A)

Fig. 11

6.Confirmation for use of sub fence (B)

WARNING

In the case of left bevel cutting, turn the sub fence (B) counterclockwise. Unless it is turned counterclockwise, the main body or saw blade may contact the sub fence (B), resulting in an injury.

This power tool is equipped with a sub fence (B). In the case of direct angle cutting and right bevel angle cutting, use the sub fence (B). Then, you can realize stable cutting of the material with a wide back face. In the case of left bevel cutting, raise the sub fence (B) up as illustrated in Fig.12 and turn it counterclockwise.

Left bevel angle

Turn Right bevel angle cutting

Direct angle cutting

cutting

 

Sub fence (B)

Fence (B)

Fig. 12

7.Oblique angle

Before the power tool is shipped from the factory, it is adjusted for 0°, right angle, left 45° bevel cutting angle and right 45° bevel cutting angle with the 8 mm set screw, 8 mm bolt (A) and 8 mm bolt (B).

When changing the adjustment, change the height of the 8 mm set screw, 8 mm bolt (A), or 8 mm bolt (B) by turning them.

When changing the bevel angle to the right 45°, pull the set pin (A) on the direction shown in Fig. 13-band incline the motor head to the right.

When adjusting the motor head to 0°, always return the set pin (A) to its initial position as shown in Fig. 13-b.

Indicator

(For left bevel scale)

8 mm set screw (Stopper for 0° not

shown)

8 mm bolt (B)

(Stopper for right 45° bevel angle)

 

Fig. 13-a

 

Set pin (A)

Indicator

Pull

(For right

 

bevel scale)

 

8 mm bolt (A)

(Stopper for left 45° bevel angle)

Fig. 13-b8.Securing the workpiece

WARNING

Always clamp or vise to secure the workpiece to the fence; otherwise the workpiece might be thrust from the table and cause bodily harm.

9