Head

Bevel angle scale

4

1 Fence (A)

Miter angle scale

TurntableBase

Fig. 46

 

Head

 

Bevel angle scale

 

Fence (B) 3

2

 

Miter angle scale Base

Turntable

Fig. 47

•Crown molding Stopper (L)

•Crown molding Stopper (R)

 

 

Crown molding

Crown molding vise ass’y

stopper (R)

(optional accessories)

(optional accessories)

 

6mm knob

6mm knob bolt

bolt

 

6mm wing bolt Crown molding stopper (L) (Optional accessories)

Fig. 50-a

(2)The crown molding vise (B) (Optional accessory) can be mounted on either the left fence (Fence (B)) or the right fence (Fence (A)). It can unite with the slope of the crown molding and vice can be pressed down.

Then turn the upper knob, as necessary, to securely attach the crown molding in position. To raise or lower the vise assembly, first loosen the 6mm knob bolt.

After adjusting the height, firmly tighten the 6mm wing bolt; then turn the upper knob, as necessary, to securely attach the crown molding in position. (See Fig. 50-b)

Crown molding vise ass’y (Optional accessories)

Fence

BA

Table on base

Fig. 48

Fence

AB

6mm knob bolt

Fence

6mm wing bolt

Knob

Crown molding

Crown molding stopper (L) Crown molding stopper (R) (Optional accessories)

Fig. 50-b

Table on base

Fig. 49

Cutting method of crown molding without tilting the saw blade

(1)Crown molding Stopper (L) and (R) (optional accessories) allow easier cuts of crown molding without tilting the saw blade. Install them in the base both-sides side to be shown in Fig. 50-a. After inserting Tighten the 6mm knob bolts to secure the crown molding Stoppers.

[Optional accessories used]

•Crown molding Vise Ass’y (Include Crown molding Stopper (L))

18

WARNING

Always firmly clamp or vise to secure the crown molding to the fence; otherwise the crown molding might be thrust from the table and cause bodily harm. Do not bevel cutting. The main body or saw blade may contact the sub fence, resulting in an injury.

CAUTION

Always confirm that the motor head (see Fig. 1) does not contact the crown molding vise ass’y when it is lowered for cutting. If there is any danger that it may do so, loosen the 6mm knob bolt and move the crown molding vise ass’y to a position where it will not contact the saw blade.