NOTE

Check and make sure on a periodic basis if the position of the laser line is in order. As regards the checking method, draw a right-angle ink line on the workpiece with the height of about 20 mm and the width of 150 mm, and check that the laser line is in line with the ink line [The deviation between the ink line and the laser line should be less than the ink line width (0.5 mm)]. (Fig. 23)

13. DIGITAL DISPLAY PANEL (for C12LSH)

Miter angle window

(Displays arrows show angle and direction that turntable is rotating. Left is Right is .)

Miter angle reset button

Bevel angle window

(Displays arrows showing motor head bevel angle and bevel direction. Left is Right is .)

Bevel angle reset button

Back light ON/OFF switch (Press and the switch illuminates. Press again and the lighting turns off.)

Fig. 24

Digital display switch

Laser marker switch

(for C12LSH)

 

(Also serves as laser marker

 

power switch.)

 

Fig.

25-a

(1)Turning on the digital display switch shows 0° for both miter and bevel angle, regardless of main unit angle.

(2)Align the main unit angle with the tilt angle (0°) and miter angle (0°) and hold down their reset buttons for at least 0.2 second.

(3)Turning on the laser marker switch while the digital display switch is on, lights up the laser marker. (On

the C12RSH, only the laser marker switch.)

CAUTION

When operating the digital panel, have the motor head section at the top limit position and the blade stopped.

NOTE

Before starting to cut, align the main unit to the miter angle 0° and the bevel angle 0° and hold down the reset buttons for at least 0.2 second. If you press the digital display switch to ON without aligning the main unit to 0°, then the figures appearing on the digital display and the main unit angle will not match.

The laser marker will not light up if the digital display switch is turned off. (only on C12LSH)

Do not use the main unit near equipment that generates electrical noise such as generators. Electrical noise might cause faulty readings or operation on the digital display.

CAUTION

If the figure shown on the miter angle digital display is different from the positive stop angle (for example, 45.0° 45.5°, 31.6° 32.0°) then the positive stop has probably deviated slightly from its correct position. If this happens, do as follows.

(1)Move the turntable left and right with the side handle loosened, and set the turntable to the correct position.

(2)If the figures on the display and positive stop still do not match, then return the turntable to the 0° position. Next move the turntable left and right with the side handle loosened as shown in Fig. 25-b. After setting it to the correct position 0°, press the reset button again as shown in Fig. 24.

Side handle

Turntable

Move the turntable left and right with the side handle loosened and set it to the correct position.

Fig. 25-b

12