English

5.Release the lever. When the lower guard contacts the work piece surface, it will be in proper position to open freely when cutting is commencend.

6.Holding the saw in position, with the blade not contacting the work piece surface, pull the trigger.

7.After the saw has reached full speed, gradually lower rear end of the saw until its base rests on the work surface.

8.Advance saw along the cutting line up to the corner.

9.Release trigger and allow blade to stop completely before withdrawing the blade from the work piece.

￿Never under any circumstances pull the saw backwards while the blade is in motion, as

kickback may result.

10.Use a jig saw or hand saw to cut the corners out clean.

11.When starting each new cut, repeat as above.

MOUNTING AND DISMOUNTING THE SAW BLADE

WARNING: To avoid serious accident ensure the switch is in the OFF position, and disconnect the plug from the receptacle.

1.Dismounting the saw blade

(1)Set the cutting volume at maximum, and place the Circular Saw as shown in Fig. 16.

(2)Depress the lock lever, lock the spindle, and remove the hexagonal-flange bolt and washer(B) with the wrench.

(3)While holding the lever to keep the lower guard fully retracted into the blade cover, remove the saw blade. (Fig. 17)

2.Mounting the saw blade

(1)Thoroughly remove any sawdust which has accumulated on the spindle, bolt and washers.

(2)For mounting saw blade, the concave sides of both washers (A) and (B) must be fitted to the saw blade sides. Mount the saw blade on the spindle, and finally affix washer (B) (See Fig. 18)

(3)To assure proper rotation direction of the saw blade, the arrow direction on the saw blade must coincide with the arrow direction on the blade cover.

Tighten

Loosen

Wrench

Lock Lever

 

Fig. 16

 

 

Lower Guard

Saw Blade

Blade

 

 

Cover

Lever

Fig. 17

14