Hitachi CB6Y instruction manual Glossary of Terms, Band SAW Terms, Woodworking Terms

English

GLOSSARY OF TERMS

BAND SAW TERMS

BLADE GUIDES – Support the blade and keep it from twisting during operation. Blade guides must be adjusted when blade is changed or replaced.

BLADE TENSION LEVER – Used to release or apply tension to blade when changing blades.

BLADE TRACKING PLATE – Adjusts blade position so blade always runs in the center of the wheel.

ON/OFF SWITCH – Has a built-in child safety lock. To lock the switch in the OFF position, remove the switch key from the switch.

RELIEF CUT – Removal of waste material by a cut from the outside edge, allowing easier cutting of intricate curves.

SAWDUST PORT – Helps keep the machine free from sawdust. The dust bag is attached to the port and collects the dust.

TABLE LOCK KNOB – Locks the table in place.

TILT (BEVEL) SCALE – Shows the degree the table is tilted for bevel cutting.

UPPER GUIDE LOCK KNOB – Locks the upper slide. Use it after adjusting the upper guide assembly to make sure upper blade guide just clears workpiece before cutting. Upper guide lock knob must be tightened before the band saw is turned on.

WOODWORKING TERMS

BEVEL CUT – An angle cut made through the face of a workpiece.

COMPOUND CUT – A simultaneous bevel and miter cut.

CROSSCUT – A cut made across the width of the workpiece.

FPM – Feet per minute. Used in reference to the surface speed of the saw blade.

FREE HAND – Performing a cut without using a fence (guide), hold-down or other proper device to prevent the workpiece from twisting during the cutting operation.

GUM – A sticky sap-based residue from wood products.

HEEL – Misalignment of the blade.

KERF – The material removed by the blade in a through cut, or the slot produced by the blade in a non-through or partial cut.

LEADING EDGE – The front edge of the workpiece pushed into the cutting tool first.

MITER CUT – An angle cut made across the width of a workpiece.

RESAW – A cutting operation to reduce the thickness of the workpiece to make thinner workpiece.

RESIN – A sticky sap that has hardened.

RIPPING CUT – A cutting operation along the length of the workpiece.

RPM – Revolutions per minute. The number of turns completed by a spinning object in one minute.

SAW BLADE PATH – The area of the workpiece or table- top directly in line with the travel of the blade or the part of the workpiece that will be cut.

SET – The distance between two saw blade teeth tips that are bent outward in opposite directions to each other. The further apart the tips are, the greater the set.

TRAILING EDGE – The workpiece edge last cut by the blade.

WORKPIECE – The item being cut. The surfaces of a workpiece are commonly referred to as faces, ends and edges.

WORKTABLE – The surface on which the workpiece rests while performing a cutting or sanding operation.

Relief Cut

Leading Edge

Saw Blade Path

Kerf

Surface

Trailing Edge

Workpiece

– 10 –