Part names
Part names
Projector
Vent (10)
Lens (17, 46)
Lens cover (6, 17)
Lamp cover (43) (Lamp unit is inside.)
Bottom side
Zoom ring (20)
Focus ring (20)
Remote sensor (8)
Speaker
Elevator button (12) Elevator foot (12)
Filter cover (9, 10, 44) (Air filter and intake vent are inside.)
Control buttons (5)
Ports (See below.)
RGB IN2 port (14) Restart switch (50) RGB OUT port (14)
Power switch (17, 18) AC inlet (16) Elevator button (12)
Elevator foot (12)
Vent (10)
RGB IN1 port (14)
RGB OUT | RGB IN2 | RGB IN1 | OUT |
CONTROL port (14)
CONTROL | AUDIO IN | |
| ||
Ports | Kensington lock slot | |
| ||
VIDEO port (15) |
|
NOTE (*) About Restart switch: This projector is controlled by an internal microprocessor. Under certain exceptional circumstances, the projector may not operate correctly and the microprocessor will need to be reset. In such a case, please push the Restart switch by using a cocktail stick or similar, and before turning on again, make the projector cool down at least 10 minutes without operating. Only push the Restart switch in these exceptional instances.