Hitachi CP-SX5500W manual No Signal Menu, Operation Start/Stop Press

OPERATIONS (continued)

No Signal Menu

The same adjustments and settings are available as with the Image and Options menus when the MENU button is pressed during display of the “NO INPUT IS DETECTED ON ***” or “SYNC IS OUT OF RANGE ON ***” message while no signal is received.

Table 8. No Signal Menu

VOLUME BLANK MIRROR START UP

MENU COLOR LANGUAGE AUTO OFF SYNC ON G WHISPER

16

Item	Description
	Volume Adjustment: Reduce VOLUME ↔ Increase VOLUME
VOLUME	• When this function is used, audio input is automatically switched to video. The
	audio input can be switched by moving the DISK PAD left and right during the
	display of the volume adjustment bar. The volume adjustment bar is displayed by
	pressing VOLUME or VOLUME button.

Select Blank Screen Color: Select the color with the and buttons.

BLANK	• The image is cleared and the entire screen is displayed in the selected color,
	when BLANK mode is set with BLANK ON, or when there is no signal for 5
	minutes.
	Operation Start/Stop: Press the	or	button.
MIRROR	Select Mirror Status: Select the mirror status with the			and
	buttons.

Operation Start/Stop: Press the or button.

Setup Initial Screen Display: Select the TURN ON with the button.

START UP Clear Initial Screen Display: Select the TURN OFF with the button.

•Note that if TURN OFF is selected the blank screen is displayed in blue when there is no signal.

MENU COLOR	Select Menu Background Color: Select the color with the and
	buttons.

Operation Start/Stop: Press the or button.

LANGUAGE Select Menu Display Language: Select the language with the and buttons.

	Operation start/stop: Press the	or	button.
	Set AUTO OFF: Set 1~99 minutes with the and			buttons. The
AUTO OFF	system automatically enters the standby mode when a signal is not
	received for the set time.
	Clear AUTO OFF: Select the STOP (0 min.) with the			button. When
	the STOP is selected the system does not enter the standby mode even
	if no signal is received.
	Operation Start/Stop: Press the	or	button.
	SYNC ON G Valid: Select the TURN ON with the			button.
SYNC ON G	SYNC ON G Invalid: Select the TURN OFF with the			button.
	• May not be displayed correctly with some input signals when the SYNC ON G is
	valid. In such cases, remove the signal connector so that no signal is received,
	set the SYNC ON G to invalid, and reconnect the signal.
	Operation Start/Stop: Press the	or	button.
WHISPER	Set / Crear WHISPER Mode: Press the		and button.When the
	WHISPER is selected, the WHISPER mode is active. In the WHISPER
	mode, acoustic moise level from the unit is reduced, and brightness
	level on screen is a little lower.

ENGLISH-16

Downloaded from www.Manualslib.com manuals search engine