Power ON/OFF

WARNINGWhen the power is ON, a strong light is emitted. Do not look into the lens or vents of the projector.

NOTE • Turn the power on/off in right order. Please power on the projector before the connected devices. Power off the projector after the connected devices.

Turning On The Power

1 Remove the lens cap.

Set the power switch to [ ] (ON).

2 The STANDBY/ON indicator will light to solid orange.

Press the STANDBY/ON button.

3 The projector lamp will light up and the STANDBY/ON indicator will begin blinking green.

When the power is completely on, the indicator will stop blinking and light green.

Select an input signal according to the

4 section “Selecting An Input Signal” of the following page.

STANDBY/ON button /

STANDBY/ON

indicator

VIDEO RGB SEARCH

ASPECT PinP AUTO BLANK

MAGNIFY

VOLUME

STANDBY/ON button

Power switch (ON position)

Turning Off The Power

1

 

Press the STANDBY/ON button.

 

The message “Power off?” will appear on

 

 

the screen for approximately 5 seconds.

 

 

Press the STANDBY/ON button again while

2

 

“Power off?” the message is visible.

 

 

The projector lamp will go off, and the

 

 

STANDBY/ON indicator will begin blanking orange.

 

 

Then the STANDBY/ON indicator will stop blinking

 

 

and light to solid orange when the lamp cooling is

 

 

complete.

 

 

Switch the power switch to [O] (OFF).

3

 

 

The STANDBY/ON indicator will go off.

 

 

Attached the lens cap.

4

 

STANDBY/ON button /

STANDBY/ON

indicator

VIDEO RGB SEARCH

ASPECT PinP AUTO BLANK

MAGNIFY

VOLUME

STANDBY/ON button

Power switch (OFF position)

14