NETWORK Menu
NETWORK Menu
Remember that incorrect network settings on this projector may cause trouble on the network. Be sure to consult with your network administrator before connecting to an existing access point on your network.
From the NETWORK menu, items shown in the table below can be performed.
Select an item using the ▲/▼ cursor buttons, and press the ►cursor button or ENTER button to execute the item. Then perform it according to the following table.
See the User’s Manual - Network Guide for details of NETWORK operation.
NOTE • If you are not utilizing SNTP ( Date/Time Settings of the User’s Manual - Network Guide), then you must set the DATE AND TIME (55) during the initial installation.
•The network communication control is disabled while the projector is in standby mode if the STANDBY MODE item of SETUP menu is set to SAVING. Please connect the network communication to the projector after setting the STANDBY MODE to NORMAL (35).
Item |
| Description |
|
|
|
| Selecting this item displays the SETUP Menu | |
| for the network. | |
| Use the ▲/▼ buttons to select an item, and | |
| the ► or ENTER button on the remote control | |
| to perform the item. | |
|
|
|
SETUP |
| Use the ▲/▼ buttons to turn DHCP on/off. |
| ON OFF | |
| DHCP | Select OFF when the network does |
| (Dynamic | not have DHCP enabled. |
| Host | • When the “DHCP” setting changes to “ON”, it takes a |
| Configuration | |
| Protocol) | little time to obtain IP address from DHCP server. |
| • Auto IP function will be assigned an IP address if the | |
|
| |
|
| projector could not obtain an IP address from server |
|
| even if DHCP is “ON”. |
(continued on next page) |
| |
54
