IMAGE Menu
IMAGE
Menu
From the IMAGE menu, items shown in the table below can be performed.
Select an item using the ▲/▼ cursor buttons on the projector or remote control, and press the ► cursor button on the projector or remote control, or ENTER button on the remote control to execute the item. Then perform it according to the following table.
/'07=4)$? | 5'.'%6 | |
| ||
2+%674' | #52'%6 | |
+/#)' | 18'45%#0 | |
+0276 | 8215+6+10 | |
5'672 | *215+6+10 | |
#7&+1 | *2*#5' | |
5%4''0 | *5+<' | |
126+10 | #761#&,756':'%76' | |
'#5;/'07 |
| |
Item | Description | |
|
| |
| Using the ▲/▼ buttons switches the mode for aspect ratio. | |
| For an RGB signal | |
| NORMAL ó 4:3 ó 16:9 ó SMALL | |
ASPECT | For a Video signal, | |
4:3 ó 16:9 ó 14:9 ó SMALL | ||
| ||
| For no signal | |
| 4:3 (fixed) | |
| • The NORMAL mode keeps the original aspect ratio of the signal. | |
| Using the ▲/▼ buttons adjusts the | |
OVER SCAN | Large (It reduces picture) ó Small (It magnifies picture) | |
• This item can be selected only for a video, | ||
| • When this adjustment is too large, certain degradation may appear | |
| at the frame area of the picture. In such a case, please adjust small. | |
| Using the ▲/▼ buttons adjusts the vertical position. | |
| Up ó Down | |
| • | |
| on the screen. If this occurs please reset the vertical position to the | |
V POSITION | default setting. Pressing the RESET button when the V POSITION | |
is selected will reset the V POSITION to the default setting. | ||
| ||
| • When this function is performed on a video signal, | |
| or component video signal of 525i (480i) or 625i (576i), the range of | |
| this adjustment depends on the OVER SCAN (above) setting. It is | |
| not possible to adjust when the OVER SCAN is set to 10. | |
| Using the ▲/▼ buttons adjusts the horizontal position. | |
| Left ó Right | |
| • | |
| on the screen. If this occurs please reset the horizontal position to the | |
H POSITION | default setting. Pressing the RESET button when the H POSITION is | |
selected will reset the H POSITION to the default setting. | ||
| ||
| • When this function is performed on a video signal, | |
| or component video signal of 525i (480i) or 625i (576i), the range of | |
| this adjustment depends on the OVER SCAN (above) setting. It is | |
| not possible to adjust when the OVER SCAN is set to 10. |
(continued on next page)
28
