Hitachi CP-X955W/E Connection to the control signal terminal, Control signal terminal

Connection to the control signal terminal

1. Control signal terminal

.	RS232C		Mouse
Pin No
		PS/2	ADB	Serial
1
2		CLK	DATA
3		DATA
4
5
6	SELO	SEL0		SEL0
7	RTS	RTS	RTS	RTS
8				D-sub 15pin shrink terminal (Male)
9		+5V	+5V
10	GND	GND	GND	GND
11
12
13	RDP
14	TDP			TD
15

Caution Turn off the power of both the projector and computer before connecting.

Connect the computer to the control terminal of the projector using an appropriate cable. Refer to the instruction manual of each device before connecting.

2.Mouse emulation

(1)Connect the projector and the mouse terminal of computer using an appropriate cable, while the projector and the computer are turn off because mouse emulation don’t work.

(2)Turn on the projector (The ON indicator will light up orange.).

(3)Press the INPUT of the projector or RGB 1/2 button of the remote control transmitter and select the input connection.

(4)Turn on the computer.

(5)Start mouse emulation mode.

If can not start mouse emulation, reset the computer. (With soft reset or reset switch)

(6)See on the page 9 about to operate the remote control transmitter.

(7)Operation speed of the mouse will vary according to the pressing force on the DISK PAD button.

Caution • In some note computers which have internal pointing device, mouse emulation don’t work without setting the internal pointing device disabled. In this case, set the internal pointing device disabled in BIOS setting. After setting in BIOS, operate (1) ~ (5) Please check its hardware manuals to disable internal pointing device in BIOS setting.

•In some computers, mouse emulation don’t work without the utility program. In this case, see and check the operating manuals of the computer.

22