6.Hammering only

This rotary hammer can be set to hammering only mode by pressing the push button and turning the change

lever to mark. (Fig. 12)

(1)Mount the bull point or cold chisel.

(2)Press the push button and set the

change lever to middle of mark and mark. (Fig. 13)

Then rotation is released, turn the grip and adjust the cold chisel to desired position. (Fig. 14)

(3)Turn the change lever to mark. (Fig. 12)

Then bull point or cold chisel is locked.

7. Using depth gauge (Fig. 15)

(1)Loosen the knob on the side handle, and insert the depth gauge into the mounting hole on the side handle.

(2)Adjust the depth gauge position according to the depth of the hole and tighten the knob bolt securely.

8.How to use the drill bit (taper shank) and the taper shank adaptor

(1)Mount the taper shank adaptor to the rotary hammer. (Fig. 16)

(2)Mount the drill bit (taper shank) to the taper shank adaptor. (Fig. 16)

(3)Turn the switch ON, and drill a hole in prescribed depth.

English

Change Lever

Push

Button

Fig. 12

Change Lever

Push

Button

Fig. 13

Grip

Fig. 14

Mounting Hole

Depth Gauge

Knob on

Side Handle

Fig. 15

Drill Bit

Grip

Taper Shank

Adaptor

Front Cap

Fig. 16

15

Page 15
Image 15
Hitachi DH 24 PF instruction manual Hammering only, Using depth gauge Fig