Cabletron Systems manual Using the EMM-E6 Hub View

Using the EMM-E6 Hub View

Figure 2-2. EMM-E6 Hub View Device Menu

The Device menu lets you perform the following:

•Open the Device Status window

•Access the IP Address Table

•Open the Polling Intervals window

•Change the Port Display Form

•Launch the Global Find MAC Address Tool

•Start the Alarm Configuration application

•Start the Link/Seg Traps application

•Start the Repeater Redundancy application

•View the Source Address List

•Access the Security application

•Start the Front Panel Redundancy application

Note that the Device menu does not provide access to every application available to the EMM-E6. Some information is only available from the Network, Module, and/or Port menus, and several applications can only be accessed either from the icon menu (if you are running under a network management platform) or from the command line (if you are running in stand-alone mode). See Chapter 1, Introduction, for a complete list of applications available to the EMM-E6 and how to access each one.

2-4 Using the Hub View