Cabletron Systems EMM-E6 manual Module- and Port-level Traps, Source Addressing

Source Addressing

Module- and Port-level Traps

To set module- and port-level source addressing traps, select the appropriate

channel in the Repeater Source Address window, then click on to

enable and disable module-level traps, or onto enable and disable port-level traps.

NOTE

It is not necessary to close the Source Address List before launching the module and port traps windows; just move the Source Address List window out of the way, if necessary, to reach the main Repeater Source Address window.

As with repeater-level trap status, a status of Other for any module indicates that there is some combination of enabled and disabled source address traps on the ports in that module.

To configure trap status for all ports on a selected module or modules:

1.In the Module Source Address Traps window (Figure 6-3, next page), click mouse button 1 to select the module for which you wish to enable or disable traps. If the Set Trap Status For field displaysSelected Modules (the default setting), you can click to select any modules; to de-select any highlighted module, click on it again. If the selection All Modules is displayed in the Set Trap Status For field, all available modules will be automatically selected; if you de-select any module, the Set Trap Status For field will automatically revert to the Selected Modules setting. To change the setting in the Set Trap Status For field, click mouse button 1 on the currently displayed setting, and drag down to select a new setting.

2.Click on the appropriate selection in the Trap Status field to enable or disable traps for the selected modules, as desired.

3.Click on to save your changes. Note that enabling or disabling traps at the module level will eliminate any module status of Other by setting all ports on the selected module or modules to the same status.

Configuring Source Address Traps 6-9