Cabletron Systems EMM-E6 Monitoring Redundancy, To set the Poll Interval, Repeater Redundancy

Repeater Redundancy

Monitoring Redundancy

Once you have configured your redundant circuits, you can use the fields in the All Circuits box to set the parameters that the EMM-E6 uses to periodically test each of the circuits. The EMM-E6 automatically polls all enabled circuits through the Primary port and all Backup ports at the time specified in the Test Time box. If the first poll fails (results in a no link condition with all of the circuit IP addresses), the EMM-E6 checks the circuit’s Retries field. If Retries is greater than 0, the EMM-E6 waits the number of seconds specified in the Poll Interval field, and then polls the circuit again.

To set the Poll Interval:

1.In the All Circuits box, type in a new value in the Poll Interval field and click . Poll Interval is the time in seconds between retries (if the first attempt is unsuccessful).

To set the Test Time:

1.In the All Circuits box, type a new test time in the Test Time field in a 24-hour

HH:MM:SS format and click . The Test Time is the time of day when the EMM-E6 polls the addresses listed in each of the enabled circuits.

To immediately test all enabled circuits:

1. Click in the All Circuits box.

5-6 Monitoring Redundancy