Cabletron Systems EMM-E6 manual What is LANVIEWSECURE?, Security, What is LANVIEWsecure?

Security

from the command line (stand-alone mode):

1.From the appropriate directory, type

spmarun r4sec <IP address> <SU community name>

NOTES

The spmarun script invoked first in the above command temporarily sets the environment variables SPMA needs to operate; be sure to use this command any time you launch an application from the command line. This script is automatically invoked when you launch an application from the icon menu or from within the Hub View.

You must use a community name with Superuser access to run the Security application.

If there is a hostname mapped to your EMM-E6’s IP address, you can use <hostname> in place of <IP address> to launch this application. Please note, however, that the hostname is not the same as the device name which can be assigned via Local Management and/or SPMA; you cannot use the device name in place of the IP address.

The Repeater Security window, Figure 7-1, will appear.

Figure 7-1. The Repeater Security Window

The Repeater Security window provides a list of the repeater interfaces available on the EMM-E6, as well as command buttons that allow you to configure security at the repeater, module, and port levels.

What is LANVIEWSECURE?

LANVIEWSECURE comprises a set of enhanced security features that have been implemented on the new generation of Cabletron’s repeater MIM family (as designated by the letter “S” at the end of the module name); these features are supported beginning with EMM-E6 firmware version 2.00.16, with the newest enhancements supported by firmware versions 3.11.xx and later.

7-2 What is LANVIEWsecure?