Cabletron Systems EMM-E6 manual Setting the Hash Type, Setting the Aging Time

Source Addressing

NOTE

The snapshots of the Source Address List that you can obtain via this feature do not reflect the current port security status of the SAT — that is, when Source Address Locking is enabled, you can still observe addresses being aged out of the table and new addresses being added as you refresh the Source Address List displayed in this window. However, the EMM-E6 remembers the addresses that were in the table when locking was enabled, and will continue to protect locked ports from access by unauthorized sources. For more information, see Locking Source Addresses, page 6-5.

Setting the Aging Time

The source address list Aging Time determines the minimum amount of time an inactive source address will remain in the Source Address Table before it is purged. The source address timer runs continuously beginning at the time the device is turned on; source addresses that are added to the SAT during one timer cycle will remain in the table for the rest of the current cycle and at least through the next complete cycle. If no packets have been received from that address during one complete cycle, the address will be purged.

The Aging Time is user-configurable, and can be set using the Aging Time text box in the Source Address list window.

To change the Aging Time:

1.In the Source Address List window (Figure 6-2, page 6-3), highlight the displayed aging time.

2.Enter your desired aging time in minutes; allowable range is 0 to 4320 (three days).

3.Click mouse button 1 on to save your change.

The new Aging Time takes effect immediately.

Setting the Hash Type

You can increase the efficiency with which your EMM-E6 handles the Source Address Table by selecting the appropriate hashing algorithm. If you are operating in a DECnet environment, or one which incorporates some DECnet elements, select the DEC hashing algorithm; if your network contains no DECnet elements (or at least none operating on the same network segment as your EMM-E6), select the non-DEC hashing algorithm. Making the wrong selection won’t do any damage, but making the correct selection will optimize performance.

To set the Hash Type for a repeater interface, or channel:

1.In the Repeater Source Address window, click mouse button 1 on the repeater interface for which you would like to set the hash type.

6-4 Setting the Hash Type