English
CAUTION:
●Do not attach the tip tool except phillips bit to the tool main unit when carrying the tool main unit with the hook suspended from a waist belt.
Injury may result if you carry the equipment suspended from the waist belt with sharp
1.1 | tipped components such as drill bit attached. | 4 | 5 | ||
Using the hook | 3 |
| |||
| The hook can be installed on the right or left side |
| |||
|
|
| |||
| and the angle can be adjusted in 5 steps between | 2 | (A) | ||
| 0° and 80°. | (B) | |||
(1) | Operating the hook | Hook | |||
1 | |||||
| (a) | Pull out the hook toward you in the direction |
| ||
|
|
| |||
|
| of arrow (A) and turn in the direction of arrow |
|
| |
|
| (B). (Fig. 7) |
|
| |
| (b) | The angle can be adjusted in 5 steps (0°, 20°, | Fig. 7 |
| |
|
| 40°, 60°, 80°). |
|
| |
|
| Adjust the angle of the hook to the desired |
|
| |
|
| position for use. |
|
| |
(2) | Switching the hook position |
|
| ||
CAUTION:
●If the tool falls, there is a risk that malfunction and/or physical damage can occur. It is recommended that you also use
●Incomplete installation of the hook may result in bodily injury when used.
(a)Securely hold the main unit and remove the screw using a slotted head screwdriver or a coin. (Fig. 8)
(b)Remove the hook and spring. (Fig. 9)
(c)Install the hook and spring on the other side and securely fasten with screw. (Fig. 8)
NOTE:
Pay attention to the spring orientation. Install the spring with larger diameter away from you. (Fig. 10)
Loosen
Hook
Screw
20
