English
●Store batteries out of the reach of children.
●Use batteries correctly in accordance with the battery specifications and indications.
2. Using the bit holder
| CAUTION: |
|
● | Stow the bit in the specified location on the tool. If | Bit |
| ||
| the tool is used with the bit stowed improperly, |
|
| the bit may fall and cause bodily injury. |
|
●Do not stow bits that are of a different length, gauge or dimension than the plus driver bit (65 mm long) included in the STANDARD ACCESSORIES. The bit may fall and cause bodily injury.
(1)Removing the bit
Securely hold the main unit and pull out the bit by holding the tip with your thumb.
(2)Installing the Bit
Install the bit with steps opposite of when removing. Insert the bit so that the right and left sides are equal, as shown in Fig. 16.
3. Installing/Removing the side handle
CAUTION:
Fig. 15
Insert so that
bit does not protrude from main unit
Fig. 16
● | Firmly install the side handle. If loose, the side | Concave | Rotate preventing |
| handle may gyrate or fall out and cause bodily |
| protrusion |
| injury. | Side |
|
(1) | Install the side handle so that the protrusions on |
| |
handle |
| ||
| the main unit and grooves on the side handle |
| |
|
|
| |
| interlock. Tighten the grip after checking that the |
|
|
| side handle is not riding on the slip prevention |
| Slip preventing |
| protrusion. (Fig. 17) | Loosen | protrusion |
| Tighten | ||
(2) | Loosen the grip to remove the side handle. |
|
4. Mounting and dismounting the bit | Grip | Fig. 17 | ||
(1) | Mounting the bit | |||
|
| |||
Loosen | Loosen the sleeve by turning it toward the left (in the | |||
Sleeve | counterclockwise direction as viewed from the front) to | |||
| ||||
open the clip on the keyless chuck. After inserting a driver bit, etc., into the keyless drill chuck, and tighten the sleeve by turning it toward the right (in the clockwise direction as viewed from the front). (See Fig. 18)
Tighten
Fig. 18
NOTE: If the sleeve becomes loose during operation, tighten it further.
The tightening force becomes stronger when the sleeve is tightened.
22
