JPEG2000 Stand alone DVR User Guide
- 14 -
2-4 HDD installation
[Steps]
1. Disassemble the bolts as illustrated.
2.Jumper setting
Set up the HDD as MASTER or SLAVE. Please
refer to the HDD manual of the jumper settings.
3.HDD Installation
Please insert the HDD as shown in
, and make sure the HDD is set as
“MASTER”.
Caution:
1. Power off the DVR before HDD installation.
2. Jumper setting must follow the instruction of HDD manufacturer.
3. Suggested HDD spec: Maxtor or Hitachi, 7200 RPM (or above), ATA-100
Maxtor, Hitachi, and Seagate if firmware version is above V1.46.
*DVR’s Firmware version can be found in [SYSTEM MENU]f[CONFIGURATION]f
[SYSTEM INFORMATION] f[S/W VERSION]
4. HDD storage 400GB (or above) is supported.
5. Don’t set the HDD as “Cable Select”
,
which ma
y
cause the DVR unable to record.