Adjust the air pressure at recommended operating pressure 80 – 120 psi (5.4 – 8.3 bar 5.5 – 8.5 kgf/cm2) according to the length of nails and the hardness of workpiece.

The correct air pressure is the lowest pressure which will do the job. Using the Nailer at a higher than required air pressure unnecessarily over stresses the Nailer.

LOADING NAILS

WARNING

￿When loading nails into Nailer,

1)do not depress trigger;

2)do not depress push lever; and

3)keep your face, hands feet and other body parts, as well as those of other persons away from the nose muzzle to avoid possible injury during usage and carrying.

￿Do not insert different length sized nail strips at same time. If do so, it could result in damaging nail strips and jamming.

￿Always point first nail protruded from the nose away yourself and others.

Keep your face, hands, feet, other body parts as well as those of other person away from the nose muzzle to avoid possible injury during usage and carrying.

English

(2) Insert nail strips from rear of magazine.

(3)Slide the nail strip forward in the magazine.

The nail strip should pass over the nail stopper, which means it is in proper position.

Nail Stopper

Nail Strip

(4)Pull the nail feeder back with depressing the feeder plate knob to push the nail strip.

Nail

Feeder

Nail point

(1) Adjust the proper position of the nail gate of the

magazine end for the nail length.

There are 2-positions, lower position for 1-1/2" (38mm)

Feeder Plate Knob

NOTE:

￿Use nail strip of more than 5 nails. The Nailer is now ready to operate.

Feeder Plate Knob

length and upper position for 2-1/2" (64mm) length.

Nail Gate

Removing the nails:

1Depress the feeder plate knob slightly and slowly

slide the nail feeder forward.

2Remove the nails from the Nailer.

￿When nails are loaded in the magazine, the nail gate can not be changed to the other position.

— 13 —