English

NAILER OPERATION

Read section titled “SAFETY”(pages 4 – 7).

DANGER

￿ Operators and others in work area MUST wear safety glasses with side shields which conforms to ANSI Z87.1 specifications.

WARNING

￿NEVER point tool at yourself or others in work area.

￿Keep fingers AWAY from trigger when not driving nails to avoid accidental firing.

￿Choice of triggering method is important. Please read and understand “METHODS OF OPERATION” found below.

￿Never place your face, hands or feet near firing head when using.

￿Use only genuine HITACHI heat treated nails for this NR65AK.

￿Be sure to position and insert the first nail point through the hole in the metal connectors.

￿Do not drive nails at an angle of less than 50 degrees, since the nails can ricochet and hurt yourself or someone else.

￿Always point first nail protruded from the nose away from yourself and others.

￿Do not push tool forward when positioning the first nail in hole.

￿Do not drive nails into thin boards or near corners and edges of workpiece. Nails can be driven through or away from workpiece and hit someone.

￿Never drive nails from both sides of a wall at the same time. Nails can be driven into and through the wall and hit a person on the opposite side.

￿Never use Nailer which is defective or operating abnormally.

￿Do not use Nailer as hammer.

￿Disconnect air hose from Nailer when:

1)it is not in use;

2)leaving work area;

3)moving it to another location; and

4)handing it to another person.

This tool has a Sequential Trip Mechanism (Single Shot) for use where precision nail placement.

You must first depress the nail point where you want to drive a nail and then pull the trigger.

After the nail is driven, completely release the trigger and lift the tool off the work surface.

This tool is not designed for contact trip operation (bounce fire), and not available for contact trip valve units.

And this tool has a new push lever (safety) mechanism, this is a different push lever mechanism from another nailers. The push lever is positioned on top at non firing and on bottom at firing.

This tool is equipped with a lockout feature that prevents the tool from being activated when there are 5 or less nails in the magazine.

METHODS OF OPERATION

There is a method of operation to drive nails with this Nailer.

It is intermittent operation (Trigger fire) only.

(1)Be sure to position and insert the first nail point through the hole in the metal connector with finger off the trigger.

Be sure to position the nail with triangle mark () at noe muzzle.

mark

Metal Hole

Keep the tool vertically when driving.

Do not push the tool forward when positioning the first nail in metal hole.

— 14 —