![](/images/new-backgrounds/1213739/21373933x1.webp)
Nail stopper 1 | 3 Open the nail guide and remove dust. | |
|
| Lubricate the sliding groove of the feeder and shafts. |
|
|
Nail guide |
|
| Shaft |
Nail stopper 2 | Nail feeder |
Nose
3. Inspect the Trigger
Clean the trigger sliding part.
Lubricate it with Hitachi pneumatic tool lubricant
Roll pin | Projection |
Sliding part
4. Inspect the muffler
In case dust choke up the muffler or muffler is damaged,
Contact Hitachi for replacement.
Muffler
CAUTION
⬤Check that the nail feeder slides smoothly by pulling it with finger.
If not smooth, nails can be driven at an irregular angle and hurt someone.
5.Inspecting Magagine
1 DISCONNECT AIR HOSE
2 Clean the magazine. Remove dust of wooden chips which may have accumulated in the magazine.
6.Storing
•When not in use for an extended period, apply a thin coat of the lubricant to the steel parts to avoid rust.
•Do not store the Nailer in a cold weather environment. Keep the Nailer in a warm area.
•When not in use, the Nailer should be stored in a warm and dry place. Keep out of reach children.
7.WARNING LABEL
Change the WARNING LABEL if missing or damaged.
A new WARNING LABEL is available from a Hitachi authorized service center.
8.Maintenance chart (See page 21)
9.Operator troubleshooting (See page 21)
SERVICE AND REPAIRS
WARNING
⬤Only service personnel trained by Hitachi, distributor or employer shall repair the Nailer.
⬤Use only parts supplied or recommended by Hitachi for repair.
All quality Nailers will eventually require servicing or replacement of parts because of wear from normal use.
NOTE:
Specifications are subject to change without any obligation on the part of HITACHI.
– 17 –