Hitachi P50S601 Accessories, Remote Control Battery Installation and Replacement

Lift up on tab to remove back cover.

CAUTION: Do not insert batteries with ‘+’ and ‘-’ polarities reversed as this may cause the batteries to swell or rupture resulting in leakage.

Bottom View (Remote Control)

First time use

Accessories

Check to make sure you have the following accessories before disposing of the packing material.

￿ Remote Control	￿ Two “AA” size,	￿ Power Swivel Table
	1.5V batteries	Top Stand (included)

￿ Power Cord Power Swivel Cable ! Wire clamp

For U.S. models: For optional accessories, please access our web site at: www.hitachi.us/tv

CANADA only: For optional accessories, please access our web site at: www.hitachi.ca/tv

CAUTION: 1. Ceiling mounting is not recommended. Mounting the panel on the ceiling does not provide adequate ventilation for the electronics or proper support for the front glass panel. This plasma television product is designed for a maximum tilting angle of 45 degrees from vertical.

2.This stand for use only with Hitachi P50S601. Use with other apparatus is capable of resulting in instability causing possible injury.

3.The wall mount unit for the 50" models is WM07S. Please see page 7 for important information related to the wall mount. Wall Mount unit is an optional accessory (Not Included).

￿ Remote Control Unit CLU-4373A	Power Swivel Cable (Part No. EW08433).
(Part No. HL02403).	! Wire clamp
￿ Two "AA" size, 1.5V batteries.
￿ Power Swivel Table Top Stand
(Part No. QJ03754)
￿ Power Cord (Part No. EV01841).

REMOTE CONTROL BATTERY INSTALLATION AND REPLACEMENT

1.Open the battery cover of the remote control by pushing down and sliding the back cover off.

2.Insert two new “AA” size batteries for the remote control. When replacing old batteries, push them towards the

springs and lift them out.

3. Match the batteries to the (+) and (-) marks in the battery compartment.

4. Insert the bottom of the battery, the (-) side, into the battery compartment first, push towards the springs and insert the top of the battery, the (+) side, into place. Do not force the battery into the battery compartment.

5.Replace the cover.

4