Hitachi P50S601 Viewing, Antenna Connections to Rear Jack Panel, VHF 75-Ohm antenna/CATV Cable TV

How to set up your new HITACHI Plasma Television

First time use

VIEWING

The best picture is seen by sitting directly in front of the TV and about 10 to 18 feet from the screen.

During daylight hours, reflections from outside light may appear on the screen. If so, drapes or screens can be used to reduce the reflection or the TV can be located in a different section of the room.

If the TV’s audio output will be connected to a Hi-Fi system’s external speakers, the best audio performance will be obtained by placing the speakers equidistant from each side of the receiver cabinet and as close as possible to the height of the picture screen center. For best stereo separation, place the external speakers at least four feet from the side of the TV, place the surround speakers to the side or behind the viewing area.

Differences in room sizes and acoustical environments will require some experimentation with speaker placement for best performance.

ANTENNA CONNECTIONS TO REAR JACK PANEL

VHF (75-Ohm) antenna/CATV (Cable TV)

R				S
4" Minimum	70	BEST
		HORIZONTAL
	5'	10'	15'	20'
	70	VIEWING ANGLE
4" Minimum

LS

When using a 75-Ohm coaxial cable system, connect CATV coaxial cable to the AIR/CABLE (75-Ohm) terminal. Or if you have an antenna, connect the coaxial cable to the same AIR/CABLE terminal.

		AIR / CABLE
			To CATV cable
VHF (300-Ohm) antenna/UHF antenna
When using a 300-Ohm twin lead from an outdoor
antenna, connect the VHF or UHF antenna leads to	To outdoor antenna	or
screws of the VHF or UHF adapter. Plug the adapter
into the antenna terminal on the TV.
		AIR / CABLE
When both VHF and UHF antennas are
connected			To outdoor VHF
			or UHF antenna
Attach an optional antenna cable mixer to the TV
antenna terminal, and connect the cables to the
antenna mixer. Consult your dealer or service store for	To UHF	AIR / CABLE	To outdoor antenna
the antenna mixer.	antenna		or CATV system

Antenna Mixer

NOTE: Connecting a 300-Ohm twin lead connector may cause interference. Using a 75-Ohm coaxial cable is recommended.

8