Controls and Functions
The controls and functions of the SBW100 and the Remote Control are explained below.
Front Panel Controls / LED Indicators
1 | 2 | 3 | 4 | 5 | 6 | 7 |
8 | 9 | 10 | 11 | 12 | 13 |
1 REMOTE CONTROL Sensor
Point your remote control at this area when you use the remote control.
Rear Panel of Soundbar
14 | 15 | 16 | 17 |
Rear Panel of Subwoofer
18
19
2POWER ON Indicator
Plug the power cord into the AC outlet. The Soundbar goes to the standby mode, and this indicator is also turned off. Press the POWER button to turn the Soundbar on, this indicator will illuminate to indicate the Soundbar is on.
This indicator will remain on as long as an input signal is active. If the input becomes inactive the Soundbar will change to standby mode to conserve power and this indicator will turn off.
3FX SURROUND (FX) / STEREO (ST) Indicator
The FX indicator lights up when FX Surround is selected. The ST indicator lights up when Stereo Mode is selected. This indicator will turn off after about 3 seconds from selecting the surround setting.
4MUTE ON Indicator
This indicator lights up when mute is on.
This indicator will turn off after about 3 seconds from turning mute on.
5MAIN VOLUME / SUBWOOFER VOLUME Level Indicator
This indicator shows the level of the main volume or Subwoofer volume when you use the MAIN VOLUME Button or the SUBWOOFER VOLUME Button respectively.
The indicator will turn off after about 3 seconds from adjusting the volume.
6INPUT SELECTION Indicator
The 1, 2, or 3 indicator lights up when INPUT 1, INPUT 2, or INPUT 3 is selected, respectively, by pressing the INPUT Button.
The indicator will turn off after about 3 seconds from selecting the input.
8
