havesufficient magnitude to cause electric shock. Therefore, it is dangerous
to make any kind of Contact With any inside part of this unit.
f
---_--_This symbol alerts the user that important literature concerning the
operation and maintenance of this unit has been included. Therefore, it
should be read carefully in order to avoid any problems.
cAuTioN:
TO PREVENT ELECTRIC SHOCKI MATCH WIDE BLADE OF PLUG TO WIDE SLOT; FULLY INSERT.
IThis Class B digital apparatus meets all requirements of the Canadian ICES-003. I
Warning: This device complies with Part 15of the FCC rules. Operation is subject to the following two
conditions: (1) This device may not causeharmful interference, and (2) thisdevice must accept any interference
received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 ofthe FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses. and can radiate radio frequency
energy and. if not installed and used inaccordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on. the user is encouraged to try to correct by one or more of the following
measures:
--Reorient or relocate the receiving antenna.
--Increase the separation between the equipment and the receiver.
--Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
--Consult the dealer or an experienced radio/TV technician for help.
Caution to the user: Changes or modifications not expressly approved by the manufacturer could void the
user's authority to operate the equipment.
Caution: Avoid operating your camcorder immediately after moving it from a cold area to a warm humid area.
Give the camcorder 2 to 3 hours to acclimate to the surroundings before inserting a video cassette. When
moved from a cold area to awarm humid area moisture may condense on the head drum inside the machine
This moisture could cause the tape to stick to the headwheel and damage the headwheel or tape.
See the bottom of the AC adaptor/charger. The rating and caution label is located on the bottom of the AC
adaptor/charger
WARNING: Many television programs and films are copynghted. In certain circumstances, copyright law may
apply to private in-home videotaping of copyrighted materials.
Any problems that occur as a result of any of the following conditions will not be covered by our warranty
D Be careful that no water, dust, or sand enters the camcorder
D When you are not using the camcorder, switch off the power and attach the lens cap.
D When you shoot at a scene which contains an extremely bright object such as the the sun or a light source, a
bright vertical bar may appear inthe picture.
Your camcorder is functioning properly, but the solid-state pickup device (CCD) usually causes thisas an
inherent characteristic. Try to avoid shooting an excessive bright object directly.
D Be sure notto leave the camcorder in aplace where the temperature exceeds 140°F (60°C), or the pickup
device may be damaged.