☐THE STAPLER MUST OPERATE.
(5)With the Stapler off the workpiece, pull the trigger. Depress the push lever against the workpiece.
☐THE STAPLER MUST OPERATE.
(6)If no abnormal operation is observed, you may load staples in the Stapler.
Drive staples into the workpiece that is the same type to be used in the actual application.
☐THE STAPLER MUST OPERATE PROPERLY.
ADJUSTING AIR PRESSURE
WARNING
English
Staple Magazine
(3)Pull the staple feeder backward. Then, detach it from the groove of magazine and softly bring the staple back as if it were being gently pushed, avoiding any impact.
⬤ Do not exceed 120 psi (8.3 bar 8.5 kgf/cm2).
Adjust the air pressure at recommended operating pressure 70 – 120 psi (4.9 – 8.3 bar 5 – 8.5 kgf/cm2) according to the length of staples and the hardness of workpiece.
The correct air pressure is the lowest pressure which will do the job. Using the Stapler at a higher than required air pressure unnecessarily over stresses the Stapler.
LOADING STAPLES
WARNING
⬤When loading staples into Stapler,
1)do not pull trigger;
2)do not depress push lever; and
3)keep Stapler pointed downward.
(1)Pull the staple feeder backward and attach it securely to a groove of the magazine.
Groove
Staple Feeder
(2)Place the staple strip over the magazine.
Make sure that the staple strip slides freely on the magazine.
Staple Feeder
The Stapler is now ready to operate.
CAUTION
If the staple feeder is released all of a sudden, it can return abruptly, causing deformation and/or scatter, eventually ending up in clogged staples.
Be absolutely sure to bring back the staple feeder, avoiding any impact.
STAPLER OPERATION
Read section titled “SAFETY”(pages 4 – 6).
DANGER
⬤ Operators and others in work area MUST wear safety glasses with side shields which conforms to ANSI Z87.1 specifications.
WARNING
⬤ NEVER point tool at yourself or others in work area.
⬤ Keep fingers AWAY from trigger when not driving staples to avoid accidental firing.
— 11 —
