English
⬤Choice of triggering method is important. Please read and understand “METHODS OF OPERATION” found below.
⬤Never place your hands or feet closer than 8 inches (200 mm) from firing head when using.
⬤Do not drive staples on top of other staples or with Stapler at too steep of an angle; staples can ricochet and hurt someone.
⬤In order to avoid double fire or unwanted ejection of a staple due to bouncing of the Stapler.
1)do not push Stapler on workpiece with strong force;
2)take Stapler away from workpiece using recoil;
3)release trigger quickly when performing trigger fire.
⬤Do not drive staples into thin boards or near corners and edges of workpiece. Staples can be driven through or away from workpiece and hit someone.
⬤Never drive staples from both sides of a wall at the same time. Staples can be driven into and through the wall and hit a person on the opposite side.
⬤Never use Stapler which is defective or operating abnormally.
⬤Do not use Stapler as hammer.
⬤Disconnect air hose from Stapler when:
1)it is not in use;
2)leaving work area;
3)moving it to another location; and
4)handing it to another person.
This Hitachi Stapler has a STANDARD CONTACT TRIP MECHANISM (Bounce File). An OPTIONAL SEQUENTIAL TRIP MECHANISM kit (SINGLE SHOT) is available as order part number 876762.
THE STANDARD CONTACT TRIP MECHANISM (Bounce Fire) is for use where rapid fastener placement is desired and must be operated in accordance with the following “Methods of Operation”.
METHODS OF OPERATION
This Stapler is equipped with the push lever and does not operate unless the push lever is depressed (upward position).
There are two methods of operation to drive staples with this Stapler.
They are:
1.Intermittent operation (Trigger fire):
2.Continuous operation (Push lever fire):
(1)Intermittent operation (Trigger fire)
1 Position the staple outlet on the workpiece with finger off the trigger.
2 Depress the push lever firmly until it is completely depressed.
3 Pull the trigger to drive a staple.
4 Remove finger from the trigger.
To drive another staple, move the Stapler along the workpiece and repeat this procedure.
Trigger
3
2
Push
Lever
(2)Continuous operation (Push lever fire)
1 Pull the trigger with the Stapler off the workpiece. 2 Depress the push lever against the workpiece to
drive a staple.
3 Move the Stapler along the workpiece with a bouncing motion.
Each depression of the push lever will drive a staple.
As soon as the desired number of staples have been driven, remove finger from the trigger.
Previously pull the trigger
1
3
Push Lever
WARNING
⬤Keep your finger off the trigger except during fastening operation, beacuse serious injury could result if the push lever accidentally contacts you or others in work area.
⬤Keep hands and body away from the discharge area. The Stapler with contact trip mechanism may bounce from the recoil of driving a fastener and unwanted subsequent fastener may be driven, possibly causing injury.
⬤Some types of loaded staples can spark out of the muzzle during a nail driving operation. Exercise caution!
— 12 —
