Hobart 5801 Upper Pulley Cover Plastic Standard, Upper Pulley Cover Stainless Steel Optional

UPPER PULLEY COVER (Plastic - Standard)

The plastic upper pulley cover (Fig. 5) should be installed on the two hinge-retainers at the top and securely latched at the bottom during use. To remove the plastic upper pulley cover for cleaning, release the latch at the bottom and remove from the hinge-retainers at the top.

UPPER PULLEY COVER (Stainless Steel - Optional)

The stainless steel upper pulley cover (Fig. 1) should be installed on the two hinge pins of the stainless steel upper pulley baffle and securely latched during saw use. To remove the stainless steel upper pulley cover for cleaning, unlatch and open the stainless steel upper pulley cover; then, lift straight up off the hinge pins.

LOWER COVER (Scrap Pan)

During use, the lower cover (Fig. 5) acts as a scrap pan, accumulating bone dust and debris from the blade scrapers and pulley wiper that are located on the lower panel (Fig. 6). To remove the lower cover (scrap pan) for cleaning, release the clip at the top; pull out and lift the lower cover from the groove at the bottom of the lower panel.

	UPPER PULLEY COVER
					LOWER GUIDE BLADE
	(PLASTIC)
								TENSION
				BLOCK
								ADJUSTER
							PULLEY WIPER
		COLUMN GUARD
						BLADE SCRAPERS
CARRIAGE
			SAW BLADE

LOWER COVER

(SCRAP PAN)

CARRIAGE LOCK

PL--40833-1

PL-40848-1

Fig. 5 Fig. 6

BLADE SCRAPERS

Two blade scrapers wipe the blade during sawing to accumulate bone dust and debris inside the lower cover (scrap pan). The left scraper points up and the right scraper points down (Fig. 6). After the blade is removed, the scrapers can slide off their mounting blocks for cleaning.

PULLEY WIPER

The pulley wiper (Fig. 6) scrapes bone dust or debris from the lower pulley during use. The pulley wiper can be removed for cleaning by springing the wiper up and sliding it off the pins.

– 4 –