CARRIAGE
In use, the carriage can roll back and forth between the left carriage stop (Fig. 9) and the right carriage stop, assuming the spring loaded carriage lock (Fig. 5) has not locked the carriage in a stationary position.
To remove the carriage, turn either of the carriage stops 90 degrees so the bumper is toward the rear (Fig. 10). Roll the carriage off either end while lifting it free of the carriage support structure (Fig. 9).
To reinstall the carriage, hold the carriage so the bearings (underneath) are aligned with the carriage support structure. Roll the carriage into place. Return the carriage stops so the carriage is stopped at both ends.
| RIGHT TABLE |
|
|
| CARRIAGE |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| LEFT CARRIAGE STOP |
|
|
|
|
|
|
| WITH BUMPER TOWARDS |
UPPER GUIDE AND GUARD |
|
|
| ||||
|
|
|
| THE REAR | |||
|
| ||||||
|
|
|
|
|
|
|
|
LEFT TABLE 
LEFT CARRIAGE STOP
CARRIAGE SUPPORT
| |
Fig. 9 | Fig. 10 |
LOWER BLADE GUIDE
The lower blade guide assembly fits in the lower guide holder (Fig. 11). The blade fits in the slots of both the steel saw blade guide and the plastic guide. When the right table is removed and the plastic guide is hinged up, the lower blade guide assembly can be removed for cleaning by lifting it out of the lower guide holder.
The steel saw blade guide is available in various widths depending on the blade being used. Contact Service to change the steel saw blade guide for other blade widths.
LOWER BLADE GUIDE ASSEMBLY
LOWER GUIDE HOLDER
Fig. 11
– 6 –
